[on4dag]

Hi Mark,

thank you for your remark. I have seen some posts on this topc and I am thinking of doing this (“oil-vacuum”) as well. But first I had to check if the other parts were all doing well.

Thanks for your help.

[on4dag]

I have reinstalled and motor is functioning!

Motor makes still some noise, from the brushes. So I have to look if these are still available.

 

[on4dag]

Hi Mark,

I had a blown fuse and only the motor module caused this.

I have tested the motor and it runned but with noise. Now I have re oiled the bearings but didn´t test the whole again. Can dry bearings cause an overcurrent to blow the fuse? If so, then I have to install it again and test it. What is your experience?

 

 

[on4dag]

Thanks all for your help.

 

I have a question on the main bearing (nylon fitting) but I will make a new topic / post

[on4dag]

Some photos of the situation.

 

 

[Author]

Posts