[MarioA]

Ok… I did indeed reset ? the room calibration and I regret it already. For some reasons the volume is not as high as it was, despite it is set to max-90, and the tweeter assembly does not recess as It did earlier in just one minute. I’m confused thou: Is there a section with advanced settings as, starting a new calibration? Or set the timer for the standby? Am I missing a portion of advanced software?
I’d love more enlightening.

Thank you again for reading this.

[MarioA]

Thank you so much for the precious info.

Beside the fact that my curiosity leads me to wanting to know what they sound like without it, the calibration performed by the installer was less that optimal to say the least. He was holding the mic with his hand throughout the entire process, and with his body standing between or near the mic as he was handling it. I know I can do a better job than that when I’ll get my hands on the microphone which I don’t have as now. Thanks again.

[MarioA]

Ok, now that the BL50 have been installed (overwhelming to say the least!) I’ve understood a little more on what you all meant. It works reasonably well although the difference in volume between RCA and spdif is huge, it still is manageable with 3rd party. Thanks again for your inputs.

[MarioA]

Thank you so much for your enlightening post. I understand that there still a need for some trickery. I realize the complexity is dictated by many diverse factors but I was hoping in a more elegant solution nowadays. Unfortunately I don’t have any other B&O hardware in the chain. Just the speakers and BR1. If it only allowed me to set different start volume corresponding to each source, that would have done it for me.

Perhaps I should have gotten a Halo instead of the BR1?

[Author]

Posts