[gpv]

Help help help
Please is there no one who can help me?
At the end of the vinyl it continues to spin, the arm does not return to STOP

[gpv]

I have another one that works and I tried to replace the processor board but the problem remained, then I also changed the display capacitors but the problem remained.
The relay works but maybe I should replace it anyway just to be safe?

[gpv]

Can anyone help me?
The screen is black, only audio is heard

[gpv]

Update, I also changed the capacitors of the power supply card, now the audio can be heard and cannot be seen (black screen).
Advice?

[gpv]

Hi everyone, I’ve partially solved it, there’s only one problem left.
When I plug it in it doesn’t turn on but when I press a button on the control faceplate it turns on and then it works.
When I unplug it and put it back the problem reappears….????
Please does anyone know the problem? And do you know what I could check to fix the problem?
Thank you.

[gpv]

Can anyone help me?

[gpv]

Finally got the job done, my beocord vx500 is now working fine.
Many tracks were interrupted and I had to make jumpers, wire more than 200 capacitors, the battery etc…

[gpv]

But this is not the vx5000 card, and then what happened to the socket for the flat cable that comes from the head

[gpv]

Maybe you mean on the right side where there is a heat sink, in this case it is normal

[gpv]

I can’t figure out where lm 701 Led Module is written on the diagram to locate the interruption of the Vu Meter. can anyone help me figure out where it is?
Thank you.

[gpv]

Thanks for the good advice I’ll try with a broken piece like yours.

[gpv]

I fixed it, it was a broken trail on the top board isolating a capacitor.
Last problem are the vu meters only one works, I can’t figure out where they are connected on the schematic.

[gpv]

Update.
I noticed that the channel balance does not work, turning left or right you hear on both speakers. Left with lower volume and right with higher volume………..

[gpv]

While playing any cassette, I also tried with a new one. Set to linear Left channel is heard with less bass… . I replaced the capacitors. Would the card you say be the one highlighted in the photo? Do I have to replace the capacitors there too?

[gpv]

I’m going crazy with this vx5000, everything seems ok but the right channel feels lower.
Who can help us?

[gpv]

ok thank you

[gpv]

Update, as the problem persists I’m inspecting the top board as I think the problem is there. It will be some ruined track or a weld.
Then I got a V8000 beocord to repair, black screen.
I can’t find the service manual by any chance does anyone have one?

[gpv]

Thank you. The photo is taken before the replacement of the capacitors, now they are all new and 105°.

While the sound card you mention I haven’t replaced anything yet, now I’ll do it right away

[gpv]

Thanks for the answer but I changed all the capacitors, maybe the old owner has calibrated it or a capacitor I changed is faulty but which one ……?

Would this be highlighted in the photo?

[gpv]

vx5000 repair update.
Yesterday I connected the vx5000 to the stereo system and I noticed that the audio of one channel is audible low.
Do you know if there is a trimmer to adjust the audio balance?.
Else what could be the problem?

[Author]

Posts