Forum Replies Created
- AuthorPosts
-
Beomaster 3500 has no timer functions and it doesn’t support two-way remote control.
Martin
11 September 2022 at 08:14 in reply to: bang & olufsen beolab penta active loudspeakers mk2 (6623) for sale #38981It would perhaps help, if you’d give us an idea about the the price and where in the world they are to be picked up.
Martin
Why not just find and buy a real one?
Martin
Currently no less than five for sale at Discogs: https://www.discogs.com/sell/release/12904500?ev=rb
Wow, – now just three left…
Martin
You’re right, thank you for pointing this to me. 9€ shipping for a 3€ record is a bit too much unbalanced to me. Nevertheless, I thought this would be more rare and will keep an eye on Discogs. Thank you Martin.
What if the record was EUR 9 and shipping EUR 3?
Martin
Currently no less than five for sale at Discogs:
https://www.discogs.com/sell/release/12904500?ev=rbI cannot see the shipping cost to France, but I don’t think the asking prices are too bad.
Martin
And here the cha-cha.
(Attached)Martin
OK,
Here the march (attached).
No singing.Martin
Good job!
Martin
A bit difficult, and it really depends on which version of drive is fitted in your Beocord.
But basically it’s a matter of rotating the flywheels by hand (Beocord unpowered) until
the tapehead bridge disengages.
Note that the two flywheels rotate in opposite directions; Left one clockwise, right one counter clockwise as seen from above.-And replace belts.
Correct belts here.Martin
There’s a march too.
Do you want them?Martin
Katy Bødtger with Deccas Dance Orchestra – B&O Stereomelodien (vals).
(Attached file).Martin
None that I am aware of.
You must take out the drive and rotate the flywheels by hand – or using some kind of suitable tool to carefully push them round.Martin
Has C7 (220uF) shorted?
Martin
During playback , do you have signal on pin 4 on both Dolby ICs?
What is the DC voltage on pin 5 (Vref) and pin 28?Martin
Which version of Beocord 9000 do you have – serialnumber?
Martin
Will the Beocord play back tapes recorded on other decks/factory recorded tapes?
Does tapes recorded on the Beocord play back correctly on another deck?Martin
Can we see a photo of your Beogram with the platter height visible?
Martin
A very low platter/subchassis setting can often cause wow.
Reason: A 12″ record is a larger diameter than the platter and the wow comes when the record touches the
surrounding surface – gradually increasing as the tonearm and carriage move inwards, shifting the subchassis’ center of gravity.
First tracks play fine, later tracks not.
The solution is to tighten up the suspension a little at the left/rear.Don’t overdo.
Make sure the subchassis is still able to move freely.Martin
Is the amplifier sections powered at all?
Bad relay?
Blown fuse?
Cracked solder joints where leads go to the relay board?
Open ceramic resistor on the relay board?Martin
- AuthorPosts