[bulldog123]

I am interested in a rosewood surround.

[bulldog123]

That is great. Thank you.

[bulldog123]

Already been re-capped. Will investigate further as suggested. Thank you.

[bulldog123]

Thank you Sonavor. Will give that a go. Btw the arm does not drop straight down as you suggest but moves slightly towards the center of the record – how do I fix this?

[bulldog123]

Yes.

[bulldog123]

Thanks Dillen – thank you for your reply. tracking force measured with scales at 1.2g. Tracking depth was off – it is now correct at o.5mm above low ribs and the tone arm does now move when I rotate the record but….now of course something is wrong with the sensor – when I nudge the tone arm to the left nothing happens – I have tried to adjust the eccentric screw on the shutter position but to no affect. Any other ideas? Could the sensor be playing up?

[bulldog123]

Apologies for any confusion. There is no TV in my setup – only display is a Sony PJ. cabling as follows:-

AppleTV 4K (4k video out)>>via HDMI>> Vertex2 (HDMI0 input)

Vertex2 (TX1 output – 1080p Video & PCM Audio) >>via HDMI>> Beosystem 4 (HDMI Input 5) >> Output via HDMI to PJ Input 1

Vertex2 (TX0 output – 4k Video) >> DIRECT via HDMI >> PJ Input2

Hope this helps.

[bulldog123]

I tried the Feintech product and could not get it to work work with my projector Sony VW-VPL590ES. I tried the HD Fury Vertex2 instead – bought from Joe at https://tmfsolutions.co.uk/?s=Hd+fury. with amazing service from Joe and great online support from HDfury the complex setup became a breeze. Now I have 4k pass through to input 1 of the PJ and 1080p video and PCM audio to the Beosystem 4 (1080p video goes into input 2 of PJ so I can still see OSD for volume and the like and view non-4k material via BS4). Appears to be stable after 20 hours of viewing. Great solution and means that my BS4 gets to go on for a few more years yet. Note I have a pair of BL5s in the setup so switching to a non-B&O AVR presented difficulties.

[bulldog123]

That was quick!

[bulldog123]

Matador – just did the re-foam – was easy thanks to your detailed instructions- thank you.

[bulldog123]

I am also intrigued by this. Steve do you supply the fixed cables or just the adapter cable to b&o ? It is the black braided fixed cables that interest me – I already have you excellent adapter cables.

[bulldog123]

I am also interested in this

[bulldog123]

#1 for me too

[bulldog123]

Great Craig. Thank you. I hope you make a speedy recovery.

[bulldog123]

Fixed. Thank you Craig and Christian. The down switch contact terminal was oxidized and bent – after cleaning and straightening it works a charm. Tone arm is dropping smoothly now. Sweet sounds are emanating from the deck and its owner. Thanks again.

[bulldog123]

Thanks Spassmaker I will look at that.

[bulldog123]

Hcraig244

in my discussions with a b&o sales rep they have stated that the bg4000 is not part of the refurbishment program – just bg4002,4004&6000. I would also like to know what they do to the electronics other than the new RIAA board.

[Author]

Posts