[loureed5]

How can I make the inbuilt DVD in the Beovision 7-40 region free.?

Step 10 in the Keith Saunders instructions requires LIST on the Beo4 until “Shift”

I have 3 different Beo4 remotes , and can’t find the “Shift” command on any of them

Help needed please

Noel.

[Guy]

To add SHIFT to the Beo4:

– Press Power (Red Button) and LIST together, the display should read ADD?

– Press GO.

– Press LIST until the display shows SHIFT then GO.

– SHIFT should then be listed under LIST

[loureed5]

Keith advised me that I need the special remote that has “Special Command 2”

on it,

Regards
Noel.

[loureed5]

Hi Guy,

Thanks heaps for your reply- I now have SHIFT on the Beo4 !

I followed Keith’s instructions , but still not region free.

It does say it’s important to disconnect the DVB-T module before making the DVD

Region Free.

Where will I find the DVB – T ?

regards

Noel.

 

[Guy]

I assume from the earlier thread that you have access to the ‘special’ Beo4 remote hence are able to get the REG2 command to show.

I too am not sure what is meant by ‘disconnect the DVB-T module’, but if you look at this FAQ it describes the DVB-T in some detail which may enable you to work out how to disconnect.

https://beoworld.dev.idslogic.net/faq_view.asp?id=93

[loureed5]

Hello again Guy,

You’re right – thanks to Mr 10% I now have the special remote that

shows the REG 2 command. And thanks to your advice , I have now got SHIFT as a

command on the Beo4.

After all that I still can’t make the DVD region free,

Regards

Noel.

 

 

[Author]

Posts