Beogram RX2 datalink

Generic selectors
Exact matches only
Search in title
Search in content
Post Type Selectors
Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #45902
    Madskp
    GOLD Member
      • Denmark
      • Topics Started 36
      • Total Posts 896

      On the Beoworld product page https://www.beoworld.ouronlineserver.com/prod_details.asp?pid=718 it is stated that the Beogram RX2 turntable is datalink compatible.

      However on the diagrams in the servicemanual no connection for datalink is shown

      RX2

      Comparing the diagram to the one for Beogram 2000 and 5000 a lot of the diagram looks identical except for the microchip for control being another one, but PIN numbers being the same

      BG2000

      Question is: Wil the RX 2 work with datalink if the diodes, resistor and capacitor shown on the diagram for the BG2000/5000?

       

      #45903
      Dillen
      Moderator
        • Topics Started 3
        • Total Posts 602

        The Beogram RX and TX (R for Radial. T for Tangential) models were intended primarily for customers having a non-B&O receiver/amplifier.
        They have twin RCA plugs from factory and none of them have datalink support.

        Martin

        #45904
        Madskp
        GOLD Member
          • Denmark
          • Topics Started 36
          • Total Posts 896

          The Beogram RX and TX (R for Radial. T for Tangential) models were intended primarily for customers having a non-B&O receiver/amplifier. They have twin RCA plugs from factory and none of them have datalink support. Martin

          ok, but the diagram in the servicemanual shows the 5pin plug, but that might just be how it was shown on the diagrams at that time

          #45905
          Dillen
          Moderator
            • Topics Started 3
            • Total Posts 602

            In the OP, your first schematics are for Beogram 1800 (= Beogram 2000 but no datalink), and the next is for Beogram 2000 & 5000.

            The RX-2 schematics shown in the same manual is wrong. It should’ve shown RCA plugs.

            Martin

            #45906
            Madskp
            GOLD Member
              • Denmark
              • Topics Started 36
              • Total Posts 896

              In the OP, your first schematics are for Beogram 1800 (= Beogram 2000 but no datalink), and the next is for Beogram 2000 & 5000.

              Ok it seems like the IC on the diagram for Beogram 1800 in the start of the servicemanual is a COP 410 where the diagram for the RX2 in the end of the servicemanual shows a ETL 9410 N. But other than that the two diagrams look very similar.

              The RX-2 schematics shown in the same manual is wrong. It should’ve shown RCA plugs.

              Yes I also see now when looking at pictures of the RX2 that it indeed has the RCA plugs.

              Thanks for pointing it out.

               

            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.