[sushistar]

I have another TT and for aesthetics I recently acquired a 5005 with an MMC3 and was an idiot not knowing that the RIAA was not in it when adding it to my 2500 system (stupidity tax). Is there a better way to connect it rather than the cumbersome PrePreamp route and gender changing din/beolink cables to RCA and back? I already have a PrePreamp for my other TT setup.

Part 2 is what about getting a user manual? Where? how much should I pay?

TIA

Peter

 

 

 

[Mark-sf]

My recommendation would be to add an RIAA board inside such as https://www.ebay.com/itm/185373986428?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=i_P7_Iv4Tsu&sssrc=2349624&ssuid=WrB3U2kWQBO&var=&widget_ver=artemis&media=COPY. This is just an example of one that can run off of the +12v single supply. I’m sure there are higher quality ones if you scout around. You can find the user and service manuals on Beocentral.com.

[Clarbasspo]

If wish I can load it for you and send it by email

Pierre

[Clarbasspo]

Hi Peter,

About the beogram 5500 manual you can download it here : https://www.vinylengine.com/library/bang-and-olufsen/beogram-5500.shtml

Otherwise about your RIAA problem for my part I’m using a Inakustik pre-amp that fit pretty well with my beogram 3000.

Pierre

 

[Clarbasspo]

Sorry, I confused between the 5005 and 5500…

There is the good link for the 5005 :

https://www.vinylengine.com/library/bang-and-olufsen/beogram-5005.shtml

Pierre 😉

[sushistar]

Pierre,

Thank you for the links, the site looks great to use however, they ask for a login/new account for the download. Unfortunately, they have turned off the “new” registration capability so I cannot access the files. Great sleuthing and resource! Thanks again!

 

P

 

[sushistar]

Thank you again, I found another that had the DIN style connectors and may acquire it so that I could wire it in between the connections from the back of the receiver. I’ll look at it a little later as sailing season is upon us!

[Author]

Posts