Hi there.
I got this fine Beogram 2200 recordplayer. But the Din connector is bad – previous owner did a bad job soldering and i want to re-solder the wires.
But what wire goes to what pin? And how do i identify the right wire for the pin – and lastly – what about the shielding ?
I hope you can help – it would be much appreciated.
regards from Denmark
Take a look at the 2200 schematic at https://beomanuals.com/manuals/Beogram/Beogram%202200/Bang-Olufsen-Beogram_2200-Schematic.pdf. It provides all that detail.
Check this photo.
Looking inside the 5-pin DIN Male plug.
Center pin – Signal Ground
Pin at 2 o’clock – Signal Right
Pin at 4 o’clock – Signal Left
Menahem Yachad
Jerusalem
.
.
.
